Pin Retainer Set - Flag and Washer

Out in the field, nothing lines up and despite best efforts, sometimes it's going to be difficult to push and pull pins on the attachments.

The flag allows you to pry and walk the pins out of the bore. If you remove the large washer on the end of the pin and install the 3/4-10 bolt back into the pin you can wail on that bolt head all you want. Once the pin is out, replace the bolt. That 3/4-10 can also be used to pull the pin into the bore, if needed.

The flag and washer setup allows the pin to be retained on both sides, making for a much more rigid connection. It's low profile, so branches and other hazards won't grab it.

Made from Grade 50 Steel. The Flag for pins 40-55mm are made from 3/8" thick material.  The Flag for pins 60-80mm are made from 1/2" thick material. The washers are made from 3/8" thick material.

The flag is meant to be welded onto the pin, as shown in the photos.

If you need something custom, please message before purchase!  

Apocfab@gmail.com